by homerjon_mistaway | Dec 31, 1969 | Nozzle Circuit
Use a 3/8″ parallel booster line if you have more than 35 nozzles in series on a run. In general, the booster line should run from just outside the unit and reconnect with the 1/4″ run at it’s halfway point. So, if you need to boost a 600’/60...
by homerjon_mistaway | Dec 31, 1969 | Gen 3 Repairs
The flow meter is the brass, cylindrical shaped component located against the back right wall of the unit. If the flow meter is plastic, See Gen 3: Replace Gray Plastic Flow Meter Time: 15 minutes Tools: zip tie snip zip tie Parts: Brass flow meter assembly...
by homerjon_mistaway | Dec 31, 1969 | iMistAway
This is Part 2 of the iMist2 setup process. Before proceeding, you must have already installed and activated the iMist2 gateway. See iMist2: Setup Part 1 – Installing and Activating the Gateway Download the iMist2 Setup Guide for printing. Pair Misting Unit...
by homerjon_mistaway | Dec 31, 1969 | Gen 1.3 - Troubleshooting
Possible Causes: Nothing to Pump: Level of liquid in drum is at or below pump intake/filter Failure to Pump: Clogged intake filter – common, but not usually the culprit Insecure pump intake – common on new systems to new dealers Pump failure –...
by homerjon_mistaway | Dec 31, 1969 | Gen 1.3 - Routine Service, Gen 1.3 – Setup, Insecticide
* Please Note: Using any non-MistAway approved concentrate with a Gen 1.3 Drum System will void the manufacturer’s warranty. Click on links for labels, MSDS and misting-specific language. Conventional Formulations in Gen 1.3 systems – with Label...
