by homerjon_mistaway | Dec 31, 1969 | Nozzle Circuit
by homerjon_mistaway | Dec 31, 1969 | Gen 3 - Troubleshooting
Because the Level Displayed is based on an internal calculation and not on an actual sensor measurement, it is possible there may be a difference between the displayed level and the actual level in the bottle. See Gen 3: How Bottle Level Display Works. Check Refill...
by homerjon_mistaway | Dec 31, 1969 | Gen 1.3 - Troubleshooting
See Gen 1.3: Controller displays “MIST”, but Nozzles Not Misting 1. Remove drum lid and confirm liquid level in drum is at or above intake filter and that filter is clean If liquid level is low, add water. If filter is clogged, clean and replace. Run...
by homerjon_mistaway | Dec 31, 1969 | Gen 3 – Setup
Leak Detection enables the Gen 3 to detect a leak in the nozzle circuit. To function properly, the leak TOLerance should be calibrated to reflect the number of nozzles on the nozzle circuit. To configure Leak Detection TOLerance for Nozzle Count DATA Menu, TOL. Press...
by homerjon_mistaway | Dec 31, 1969 | Gen 3 Repairs
The float switch is mounted to a bracket over the back left corner of the batch tank. A buildup of residue on the post that hinders the movement of the float is the most common cause of failure of the switch to operate. If this is the case, you can clean (rather...
