by homerjon_mistaway | Dec 31, 1969 | Gen 3 - Troubleshooting
All Gen 3 and Gen 3+ units use a bellows-type dosing pump to meter insecticide from the cartridge into the mixing vessel. Each dosing pump contains two small valves. Gen 3 and Gen 3+ units sold prior to 2016 used a dosing pump with valves known...
by homerjon_mistaway | Dec 31, 1969 | Gen 3 Repairs
Time: 10 minutes Tools: snip for zip tie and small zip tie paper towels to blot concentrate Parts: Gen 3 Coupler (#21060) 1. Remove bottle. Reposition controller and shroud. See Gen 3: Access Components by Repositioning Shroud. 2. Remove existing coupler and...
by homerjon_mistaway | Dec 31, 1969 | Gen 3 Repairs
The float switch is mounted to a bracket over the back left corner of the batch tank. A buildup of residue on the post that hinders the movement of the float is the most common cause of failure of the switch to operate. If this is the case, you can clean (rather...
by homerjon_mistaway | Dec 31, 1969 | Gen 3 Repairs
The flow meter is the gray component with the red and black leads located against the back right wall of the unit. This component was used in Gen 3 units sold from 2007 – 2011. It is no longer available and must be replaced with a brass flow meter. This also...
by homerjon_mistaway | Dec 31, 1969 | Gen 3 Repairs
The flow meter is the brass, cylindrical shaped component located against the back right wall of the unit. If the flow meter is plastic, See Gen 3: Replace Gray Plastic Flow Meter Time: 15 minutes Tools: zip tie snip zip tie Parts: Brass flow meter assembly...
