by homerjon_mistaway | Dec 31, 1969 | Gen 1.3 - Troubleshooting, Gen 3 - Troubleshooting
Potential Causes: System Mode is set to OFF or REM (or ON) and should be set to AUTO EVERYDAY or AUTO-CUSTOM. See Controller: Setting System Mode There are no AUTO MIST cycles defined. See Controller: Setting AUTO MIST Cycles The controller has calculated that the...
by homerjon_mistaway | Dec 31, 1969 | Controller & Remote, Gen 1.3 – Setup, Gen 3 – Setup
The “iMist2-ready” handheld transmitter with the light colored label will communicate with the white “iMist2-ready” receiver but not with the first generation (black) receiver. 1. Put the iMist2-ready receiver on the misting unit into...
by homerjon_mistaway | Dec 31, 1969 | Insecticide
Pyrethrins (botanical), Permethrin (synthetic) and Piperonyl Butoxide (PBO) are the most common active ingredients found in mosquito misting formulations. Click on the links below to download National Pesticide Information Center (NPIC) fact sheets that answer...
by homerjon_mistaway | Dec 31, 1969 | Uncategorized
An effective mosquito misting system starts with a good plan. The videos in this article describe the design process and the factors you should consider as you work through it. System Design Guidelines Design a “perimeter of protection.” Place nozzles ten feet apart....
by homerjon_mistaway | Dec 31, 1969 | Gen 3 Repairs
Time: 15 minutes Tools: 15 mm wrench crescent wrench or channel lock pliers 5/16″ nut driver Teflon tape snip for zip tie and small zip tie paper towels to blot concentrate Parts: Replacement Pressure Gauge Assembly – Includes Gauge and Fitting (SKU...
