by homerjon_mistaway | Dec 31, 1969 | Gen 3 - Troubleshooting
What is ERR0? ERR0 is displayed when the controller detects that the float switch did not drop during the previous mist cycle. Either the solution level in the batch tank did not drop enough for the float to drop, or The solution level dropped, but there is a problem...
by homerjon_mistaway | Dec 31, 1969 | Gen 3 - Troubleshooting
The displayed level of concentrate remaining in the bottle is calculated and not measured. The factors used in the calculation are the Starting Level (entered in the controller when filling the unit) and information about the dosing pump – Dosing Pump Target...
by homerjon_mistaway | Dec 31, 1969 | Gen 3 Repairs
The bellows pump is the black and blue component mounted to a bracket on the left back wall of the unit. Time: 15 minutes Tools: Phillips head screwdriver (magnetized) zip tie snip and zip tie paper towels for blotting concentrate Parts: Gen 3 Mini Bellows Pump,...
by homerjon_mistaway | Dec 31, 1969 | Gen 1.3 - Routine Service
1. Inspect Unit and Clean Filters: Remove drum cover Confirm unit top is clear of debris Unlatch gray drum ring and reposition lid to access inside of drum Strain floating residue if needed Inspect and clean intake filter Inspect and clean inline nozzle circuit filter...
by homerjon_mistaway | Dec 31, 1969 | Gen 1.3 - Troubleshooting
What is ERR3: ERR3 is displayed when the actual MIST volume is significantly greater than the target volume. Most Common Cause: leak in the nozzle circuit. Other Potential Causes: There are more nozzles installed in the nozzle circuit than entered as the NOZ count in...
