by homerjon_mistaway | Dec 31, 1969 | Gen 3 - Troubleshooting
What is ERR4? ERR4 is displayed when the batch tank took too much time to fill after the previous mist cycle. Most Common Cause: Faucet supplying water to the unit has been shut off. Note: If faucet is shut off – causing ERR4 – and then turned back on,...
by homerjon_mistaway | Dec 31, 1969 | Gen 3 – Setup
iMist2 is our second generation wireless technology that allows our dealers to monitor and manage misting units over the internet. For an introduction to iMistAway, see iMist – Intro Video (8:41) For installation instructions, see iMist2: Setup Part 1-...
by homerjon_mistaway | Dec 31, 1969 | Gen 3 – Setup
Pictured: Gen 3 Zone Kit, mounting screws and length of 1/4″ tubing. 1. Disconnect power to the unit. The zone kit will be recognized when the controller boots up after the Zone Kit is connected. 2. Remove the black plastic plug from access port and push...
by homerjon_mistaway | Dec 31, 1969 | Controller & Remote
Gen 3 STATUS DISPLAYS AGT Unit is agitating contents of batch tank. DOSE Unit is adding insecticide to batch tank through dosing pump. DRN Drain. Unit will mist until batch tank is empty and pressure falls. FILL Inlet supply valve is open and filling batch tank...
by homerjon_mistaway | Dec 31, 1969 | Gen 1.3 – Setup, Gen 3 – Setup
Content coming soon! Establish Optional Wind Sensor SET-UP Menu, SEN If sensor installed, ON. Otherwise, set to OFF. Set Max Wind Speed (wind sensor required) SET-UP Menu, WND Set max wind speed Verify ALT value is...
