by homerjon_mistaway | Dec 31, 1969 | Nozzle Circuit
Follow these rules to optimize the flow out of your nozzle circuit! 1. Adjust the pump bypass to produce 250 psi at the unit, never higher. Watch the video, Basics – The Pump (7:41) 2. Each nozzle should operate in the “Target Misting Zone” between...
by homerjon_mistaway | Dec 31, 1969 | Controller & Remote, Gen 1.3 Repairs, Gen 3 Repairs
IMPORTANT: Before disassembling the controller, touch your hand to a metal object to discharge any static. Time: less than 5 mins Tools: small Phillips screwdriver Parts: Gen 3/1.3 Controller Faceplate with Buttons (#21050) 1. Remove faceplate from controller....
by homerjon_mistaway | Dec 31, 1969 | Controller & Remote
See the video at Installation – Navigating the Controller (1:50) Set System Mode On the home screen, which shows day and time, press Green ► button to position ▲at top of display to one of four System Modes: OFF – daily agitation cycle only. REM...
by homerjon_mistaway | Dec 31, 1969 | Gen 3 Repairs
The primary cause of failure in the remote receiver is water entering the connection with the CAT 5 cable. When replacing the remote receiver, we advise also replacing the receiver cable and antenna. Time: 5 minutes Tools: 5/16″ nut driver Parts: Gen 1.3/3...
by homerjon_mistaway | Dec 31, 1969 | iMistAway
Download the iMist2 Setup Guide for printing. Pictured: iMist2 Gateway, antenna, power adapter, ethernet cable Connect Gateway to Internet Locate the modem or router that provides an internet connection to customer’s property. Thread articulated antenna (yellow...
