by homerjon_mistaway | Dec 31, 1969 | Gen 3 – Setup
Gen 3 is designed to recognize problems with its operations and display error messages that facilitate quick troubleshooting. These error conditions suspend the operation of the unit until the error is clear by pressing and holding the Red MENU/Stop button for 5...
by homerjon_mistaway | Dec 31, 1969 | Gen 1.3 - Troubleshooting
Displayed Level is greater than Actual Level Possible Causes: Actual flow rate is greater than the controller Target Flow Rate (NFR entered into the DATA Menu) – which may also point to a leak or siphon in the nozzle circuit. Actual nozzle count is greater than...
by homerjon_mistaway | Dec 31, 1969 | Gen 1.3 Repairs
Time: 20 minutes Tools: Phillips head screwdriver 1/2″ ratcheting wrench 1/4 nut driver or flathead screwdriver needlenose pliers (optional) Parts: Gen 3/1.3 Motor – 1/2 HP (#10800) 1. Reposition controller and plastic cover. See Gen 1.3: Access...
by homerjon_mistaway | Dec 31, 1969 | Controller & Remote
MIST Button Activates a REMOTE MIST for the duration defined in the SET-UP menu. (SET-UP Menu, REM, Set duration in seconds) An agitation cycle may precede the REMOTE MIST, depending on the remote agitation duration configured in the SET-UP menu. (SET-UP...
by homerjon_mistaway | Dec 31, 1969 | Gen 3 - Troubleshooting
Note: In this video, you will see water with red food coloring (rather than insecticide concentrate) moving through the clear tubing on the discharge side of the bellows pump. There is a brief shot of the bellows pump in operation (0:12 – 0:19) that you will...
