by homerjon_mistaway | Dec 31, 1969 | Gen 1.3 - Troubleshooting
For Gen 1.3 units without leak detection: The displayed level of solution remaining in the drum is calculated using factors entered into the controller during the setup process – Tank Size, Starting Level, Nozzle Count, Target Flow Rate New Level = Old...
by homerjon_mistaway | Dec 31, 1969 | iMistAway
Download the iMistAway app from either iTunes or the Google Play store. For iPhone app, click here For Android app, click here
by homerjon_mistaway | Dec 31, 1969 | Gen 3 - Troubleshooting
Most Common Cause Inlet solenoid valve is jammed in the open position. This is usually a result of sediment in the water line This is preventable by using the Inlet Water Filter (Part #10860) shipped with the unit. Other Potential Causes Float switch is not...
by homerjon_mistaway | Dec 31, 1969 | Gen 1.3 - Routine Service, Gen 3 - Routine Service, Nozzle Circuit
Clogged nozzles significantly reduce the flow rate/volume of mist and result in loss of system effectiveness. Usually the problem is that the filters inside the nozzles tips are fouled, although in some cases the orifice of the nozzle is clogged by scale from hard...
by homerjon_mistaway | Dec 31, 1969 | Uncategorized
The REFILL routine in the MAINTENANCE Menu of the controller prompts the user to input the target MIX of water and insecticide, expressed in Parts Water to Concentrate. This value must be calculated from the mixing instructions found on the insecticide label:...
