by homerjon_mistaway | Dec 31, 1969 | Controller & Remote
flashing sun symbol indicates that the previous mist was skipped for one of three reasons: 1. The user triggered a SKIP NEXT MIST with the remote, and the most recent AUTO MIST was skipped. The next AUTO MIST will be executed as programmed. 2. The Maximum Daily Mist...
by homerjon_mistaway | Dec 31, 1969 | Controller & Remote
Reset controller to factory settings Either unplug unit from the outlet or remove the black connector from the port on the back of the controller marked “Power In” Press and hold MENU and ▲ buttons simultaneously while restoring power to unit. Watch for...
by homerjon_mistaway | Dec 31, 1969 | Gen 1.3 - Routine Service
1. Connect power to unit Plug unit into GFCI outlet 2. Confirm clean drum and run INSpection cycle. Confirm pump pressure. Check drum and clean if needed. Check and clean pump intake filter if needed. If tank is empty, fill 1/2 full with fresh water only (no...
by homerjon_mistaway | Dec 31, 1969 | Gen 3 Repairs
The inlet water valve is the silver cylinder mounted to the back wall in the lower right corner of the unit. The sidewalls must be removed to access it. The primary failure mode is rust or sediment that enters the valve body and prevents the plunger from closing...
by homerjon_mistaway | Dec 31, 1969 | Gen 3 - Routine Service
1. Inspect Unit and Clean Filters: Inspect and clean inline nozzle circuit filter Inspect and clean inlet water filter 2. Note Controller Info: Confirm clock day and time is correct. Note indicated insecticide level (bars) and compare to actual level Note AUTO Cycle...
