by homerjon_mistaway | Dec 31, 1969 | Gen 3 Repairs
Some Gen 3 component repairs and replacement – inlet water valve, pump, motor – require that you remove the sidewalls to access those components. Time: 5 minutes Tools: Phillips head screwdriver 1. Remove sidewalls, then reposition...
by homerjon_mistaway | Dec 31, 1969 | Gen 1.3 – Setup
Download the Gen 1.3 Operating Manual for printing. See Gen 1.3: Setup Checklist Watch Setting Up a Gen 1.3 Drum Unit (12:19) See Controller: “Learning” the iMist2-ready Handheld Remote Transmitter See Gen 1.3: Approved Insecticides See Gen 1.3 –...
by homerjon_mistaway | Dec 31, 1969 | Gen 3 - Troubleshooting
What is ERR5? ERR5 is displayed when the batch tank volume exceeds its maximum. Most Common Cause: The unit has a Brass flow meter, but the unit has been inadvertently set up in the controller to accept the input of a Plastic flow meter (used in older systems, now...
by homerjon_mistaway | Dec 31, 1969 | Gen 3 – Setup
Download the Gen 3 Operating Manual for printing (English) See Gen 3: Setup Checklist Watch Setting Up a Gen 3 Tankless Unit (13:38) See Controller: “Learning” the iMist2-ready Handheld Remote Transmitter See Gen 3: Approved Insecticides See Gen 3...
by homerjon_mistaway | Dec 31, 1969 | Gen 3 - Troubleshooting
What is ERR6? ERR6 is displayed when the flow meter reading is zero after a FILL routine Most Common Cause: Flow meter is either clogged or failed. Other Potential Causes: Float switch is stuck in the up position at the end of the mist (due to buildup of residue on...
